Nilight Horn Push Button Switch 12V (ON) Off Momentary Switches with Connector Wire Kit 1.54" x 0.83" Replacement for Toyota FJ Cruiser Fortuner Tacoma Highlander Tundra 4Runner Prado Land Cruiser

This switch was easy to install and fit my Toyota Land Cruiser Prado 120 (same as Lexus GX470) perfectly. The bottom LED comes on when I start the truck so I can find the switch in the dark, and I used a fuse tap hooked up to my tail light fuse so the actual accessory LED comes on as soon as I press the switch. The switch works perfectly with no binding as it seems to be of OEM quality.

Switched worked as decribed and quality was good

The switch doesn’t fit snugly so it rattles a little bit. Overall it’s a working switch.

Worked fine for a couple of days. Then the button seemed to get stuck and would not click on and off reliably. I was able to click it one last time to turn on the lights i installed it to, but i began to smell plastic burning. It shorted out internally and burnt a hole through the casing. I had to uninstall it going down the road because the switch would not turn off. Cheap defective product. Returning and looking for a better alternative. On a side note, it did fit right in and would have been great if the internal parts had not failed. The casing fit right in a 4 runner. Just junk on the inside and a fire hazard.

Works great, easy to install, clear instructions.

I have a 1st Gen Sequoia and apparently there's a common issue where every 12v power outlet with exception to the cig lighter stops working. I replaced fuses but nothing. Come to find out that others have the same issue and the culprit was Toyota's Intelligent Power Outlet board getting fried due to water damage. I was pretty much left with two choices: Replace the entire Fuse Box($$$$$$$) or Bypass the IPO relay. I did the latter by following the instructions provided by CarlosClasson on the Toyota Nation forum. IT WORKED!!! Buuuut now I had a feature/bug. I went from No Power Outlets to Always On power outlets. Which was cool but I wired a LED QC USB charger to the power outlets. So although minimal, could still drain my battery after a couple days. Enter this switch. Basically rather than having a jump wire give constant power to my outlets. This switch gives me manual control of my Always On Outlets and with the added benefit of being lit up when power is on but the car is off, I can't forget to turn the power off. It's a really sick mod and this switch really is the chef's kiss.

Looks great and fits 2021 Tacoma switch openings perfectly. It’s not loose at all like I thought. Overall worth the price but not much more.

Easy to install, worked perfect on my Toyota Tacoma.

Didn’t fit even though Amazon said it would

Easy to install, instruction come with the switch. 3 different installation harness possible. Looks great

The product is fine, thank you.

Great fit into my 2013 tacoma, easy instructions for wire hookup.